Using one (1) of the 2-56x3/8"FH screws, attach the bottom of the rear shock tower to the very last hole in the Vortex Chassis. (See the picture above).

Now remove the right rear wheel. Using the soldering iron/gun, swap the red and black wires ont the motor. This will reverse the polarity of the motor allowing it to turn in the opposite direction.(See the picture to the right).

Install the steering servo and top plate with the four standoffs and (4) 2-56x1/2" SH screws. See the picture to the right).

Next install the front (2) standoffs for the front nose plate with (4) 2-56x1/2" SH screws. (See the picture to the right).

Now install your electronics (receiver, esc, servo) on the right side of the chassis as these are the lighter parts. This will leave the left side for your battery which is much heavier. See the picture to the right).

Lastly, remove and trim the gear cover. Trimming off the edge where it comes in contact with the Vortex Chassis. Then re-install the gear cover with the (3) 2x4mm. SH screws.